| Size Range : |
Up to 2500mm x 2500mm high. |
| Applications : |
A small, neat, lightweight door with photocell protection for internal openings for conveyor, personnel and In-store use. |
Motor : |
In-line helical bevel geared braked motor. Two speed 98/180 rpm 0.7/0.9 kw. Class IP 54.
Opening speed 1.5 m per second (average).
Closing speed 0.75 m per second. |
| Control : |
Electronic PCB self diagnostic – will accept multiple forms of activation signal. Incorporates independent timers to control all aspects of cyclic modes.
Enclosures to IP 64. |
Limit Switches : |
3 cam Stromag limit switch box shaft driven from motor Brake output. |
Manual Brake Release : |
Facilitates manual opening of door in the event of an Electrical power supply failure. Roll can then be Manually rolled. |
Bottom Beam : |
Ultra Lightweight bottom beam comprising windbrace in pole pocket with flexible windbrace end tabs to provide crash out facility. |
Side Guide Columns : |
Fabricated from 120 x 120 x 5 SHS with 3 mm pressed steel blade guides. |
| Top Roll : |
168.3 diameter x 5 mm wall CHS tubing terminating at each end with 30 mm diameter EN8 stub shafts running in self aligning flanged roller bearings. |
Door Blade : |
Double PANAMA PVC coated polyester, complete with clear PVC vision panel or supplied in fully opaque. Blade incorporates steel wind bracings within pole pockets. All joins high frequency welded.
Colours – Full range of colours available. |
| Final Transmission : |
5/8” simplex chain drive. |
SEALS |
|
Top : |
Dual purpose back bar (100 x 60 x 3.6 RHS) performs the role of top seal and brush damper support. |
Side : |
Powder coated 125 x 30 x 18 SWG angle pressing (vermin exclusion as standard). |
Finish : |
All metal parts fully shot blasted and degreased, zinc phosphate pre-treated and finally polyester powder coated to 70 microns.
Standard Colour – grey gloss to RAL 7043. |
| Door Clearances : |
See Clearance Drawings |
OPTIONAL EXTRAS |
|
Motor : |
- Single speed (at no extra cost).
- Zone 1 rated specification (prices on application).
|
| Control : |
- 2/3 or partial opening facility.
- Interlinking with other processes or equipment.
- Airlock configurations
|
| Blade : |
- Fully opaque.
- Non standard colours.
- Hand lettering with company logos/hazard warnings.
|
| Finish : |
- Powder coating in non standard colours.
- Stainless Steel option.
|
| Seals : |
- Bird exclusion.
- Non standard top and side when fitting to irregular fixing faces.
|
| Top Roll Covers : |
Powder coated galvanised steel or stainless protective hoods for sensitive internal locations |
| Activation : |
- Radar
- Photocell
- Induction loop (Single, Directional & Safety Loops)
- Radio Control
- Push Button (Single, Double or Mushroom Push Button Stations)
- Pull Cord Switches
|
| Windbar Systems : |
Not applicable. |
| Additional Safety Features : |
See Standard Health & Safety Features - HSE guidelines |
